You don’t really need, but the cheating way of doing this, if you go all the way up to the top and you’ll, see a little piece of paper here with a check mark and then right to the right of it. It’ll, look like this got a whole bunch of internet. It is now right here is your two different um ecms and, like I said, usually, both will work, but just to be on the safe side, open it up and double check everything, and then once it all opens up. It’ll pop up go in here where your calibration workspace is keep opening it up, automotive and there. Get it out of the way, remember your uh part number, and then you just go down to your calibration section and then once you’re in here, you just click in here to get it open. I like to do it this way, so that way, you know you got the right ecm code for the correct ecm, that’s in the trunk and, like I said most of the time, it’ll work um, but you just go up here to your system id open that tab up and then just go down here to ecm information, real simple and then you’ll go right down to right here where it’s ecm part number and you’ll see your part number on the right hand, side there, and then I just click back on features and parameters.

Probably wouldn’t do anything truck would still run. You’ll uh you’ll have multiple ecm codes with the updates and you could always click on the wrong one. Some people don’t, but I always go in here- to features and parameters first, sometimes depending on the trucks. You can exit out of it and like that go on over here to exit um. Um very simple: just go right here on the bottom left where it says: save click on save it’s going to save it into your into your computer here in the program very self explanatory, once it saves in it’ll stop doing this little thinking thing here. It is popped up, right away and it’ll go through and it’ll tell you that there is an update. If everything goes the way it should okay, now it came into the actual program here and they said should pop there. She should pop right into the program into the ecm on the truck and I’ll just kind of hopefully show you the quick way of doing it. Let’s go up here in our inside program to connect to ecm, then come back down and click on connect again and after a couple seconds here. Um we have the ignition key on truck is not running. I know that there’s one out there, so I’m going to plug this truck in and should be able to show you how it automatically show you How to update Cummins ECM by Cummins INSITE Software.

All right guys, I’m going to show you what happens when you got to do an update to an ecm.

Odometer setting cummins insite